Filter
Top Products
4. Press the ENTER key and the timing pattern in
mode A (or mode B) will be printed.
Numbers marked with asterisks indicate the currently set
timing numbers. In mode A, modes 1 to 11 are printed. In
mode B, modes 0 to 11 are printed.
In each mode, 13 timing patterns are printed.
5. Select a speed mode number to be changed in the
printed patterns.
6. Select the best aligned pattern in the same speed
mode.
Check the alignment of the two line"H"printing.
7. Then press the ENTER key.
The selected timing is temporarily stored in the printer, and
test printing is executed at that timing.
8. Repeat steps 5 to 7 to change the speed modes.
9. Press the EXIT key to finish setting.
The timing stored temporarily is saved in the setup memory
(EEPROM). Therefore, be sure to press the EXIT key to exit
the mode.
10. Processing when the EXIT key will be pressed
differs according to the mode as shown below.
a. If mode A is exit, the menu of mode B will be displayed.
Press the ENTER key, and the patterns of mode B are
printed. Hereinafter, follow step 5 and so on.
b. If mode B is exit, the printer is reset automatically and
exits mode B.
4-7
— 4. Functions —
A-MODE 1: NO.6
A-MODE 3: NO.6
Select with or key.
For example, mode 1 is changed to mode. 3.
A-MODE 3: NO.6
A-MODE 3: NO.8
Select with or key.
For example, mode 6 is changed to mode 8.
●
Functions