Filter
Top Products
8-1
—
8. Software commands
—
BEL (07)D (07)H
Activates the printer buzzer.
BS (08)D (08)H
Moves the printing position leftward by one character.
HT (09)D (09)H
Moves the printing position to the next horizontal tab.
LF (10)D (0A)H
Single line feed
Causes a carriage return if #28
LF SETTING is set to CR + LF
in
the EXTENDED SETUP MODE.
VT (11)D (0B)H
Vertical tab
Causes a carriage return if #28 LF SETTING is set to CR + LF in
the EXTENDED SETUP MODE.
FF (12)D (0C)H
Form feed
Causes a carriage return, regardless of the setting in the
EXTENDED SETUP MODE.
CR (13)D (0D)H
Carriage return
Executes a line feed after a carriage return if #27 CR SETTING
is set to CR + LF or #27 CR SETTING is set to AUTOFEED and
the parallel AUTO FEED signal is low.
SO (14)D (0E)H
Double-width printing on a single line.
SI (15)D (0F)H
Specifies condensed mode (from 10 cpi to 17 cpi, 12 cpi to 20 cpi, or
proportional to condensed proportional). Valid only when #34
PITCH LOCK is set to NO in the EXTENDED SETUP MODE.
DC1 (17)D (11)H
Printer select
Cancels the input data ignoring condition which is set by the DC3
(deselect) code. Valid when #71 SELECT IN ENABLE is set to 1
in the EXTENDED SETUP MODE or SELECT IN ENABLE is
selected to I/F and the SELECT IN signal is high.
DC2 (18)D (12)H
Cancels condensed mode.
DC3 (19)D (13)H
Printer deselect
Puts the printer into the deselect state. Valid when #71 SELECT
IN ENABLE is set to 1 in the EXTENDED SETUP MODE or
SELECT IN ENABLE is selected to I/F and the SELECT IN
signal is high.
DC4 (20)D (14)H
Cancels the double-width mode established by the SO command.
CAN (24)D (18)H
Cancel
Clears all data in the print buffer and printing position specified
with the horizontal position move command (HT, ESC $, ESC \,
etc.).
DEL (127)D (7F)H
Deletes a character.
ESC (27)D (1B)H
Designates ESC sequence.
ESC SO (27)D(14)D (1B)H (0E)H
Double-width printing on a single line.
ESC SI (27)D(15)D (1B)H (0F)H
Specifies condensed mode.
ESC EM (27)D(25)D (1B)H (19)H
Specifies the paper path.
nn n
n="R" : Ejects paper.
n="B" : Feeds paper with the rear tractor.
n="F" : Feeds paper with the front tractor.
n="M" : Feeds manually loaded paper.
n="f" : Ejects paper to the front.
n="t" : Ejects paper to the top.
n="r" : Ejects paper to the rear.
Decimal Hex
Symbol
Function
Code
EPSON Software commands
8.
Software commands