Filter
Top Products
P
Paper ..............................................................1-8
PAPER FORM key .........................................2-4
Paper jam detection ......................................3-44
PAPER PATH key ..........................................2-2
Parallel interface
AUTO FEED signal .............................7-3
ACK signal ..........................................7-4
BUSY signal ........................................7-4
ERROR signal .....................................7-4
INITIAL signal ......................................7-3
PE signal .............................................7-4
SELECT signal ....................................7-4
SELECT IN signal ...............................7-3
STROBE signal ...................................7-3
Data latch timing ................................3-53
Timing chart
Data input .....................................7-2
Initialization ..................................7-2
Power consumption ......................................10-6
Power cord ................................................vi, 1-1
Print head .....................................................viii, ix
Print mode specifications ...............................10-2
Printing area .............................................1-8, 1-9
Printing direction ............................................3-55
Print method ..................................................10-1
Printing out
Smudging paper ...................................6-6
Correcting vertical misalignment.......... 4-6
Printing speed ...............................................i, 4-1
Q
QUALITY key ..................................................2-3
R
RESET key .....................................................2-1
S
S.D. (Speed Draft)........................................... 4-1
S.S.D. (Super Speed Draft) .............................4-1
Saving data in format memory ......................3-24
Selecting emulation .......................................3-25
Selecting interface .........................................3-46
Selecting paper path .......................................1-6
Setting option .................................................3-41
Setting serial interface
Parity bit ............................................3-47
Data length ........................................3-48
Stop bit ..............................................3-48
Protocol .............................................3-49
Baud rate ...........................................3-49
Serial error .........................................3-50
CTS signal ..................................3-50, 7-6
CIN ....................................3-52, 7-8, 7-11
CD signal .....................................7-7, 3-51
CRN .................................3-52, 7-8, 7-11
DSR signal .................................3-51, 7-6
DTR protocol ..............................3-49, 7-8
DTR signal ...........................................7-7
EXT/ACK protocol .....................3-49, 7-11
RXD signal ..........................................7-6
RTS signal ...........................................7-7
TXD signal ..........................................7-7
SRTS signal .......................................7-7
X-ON/X-OFF (I)/(II) protocol .......3-49, 7-9
Setting the printing start position .....................4-2
Setup modes
Outline .................................................3-1
Key type ..............................................3-2
Factory defaults setting .......................3-6
Setting example ...................................3-3
Saving data in format memory ..........3-24
Printing setup list ................................3-57
Enter/Exit ......................................3-1, 3-3
Loading data from format memory ....3-24
Skew detection .............................................3-43
Software command
EPSON ...............................................8-1
IBM ......................................................8-9
HP .....................................................8-18
Bar code .............................................5-2
Enlarged character function ..............5-16
Software setup ..............................................3-40
Command ............................................9-2
Setup functions ....................................9-1
Specifications ...............................................10-1
T
TEAR OFF key ...............................................2-1
Throughput ...............................................i, 10-5
TOF SET key ...................................................2-3
Top of form (TOF) adjustment ................3-10, 4-2
Troubleshooting ...............................................6-1
U
Unpacking ..................................................... v, vi
Using various types of paper .................1-10, 4-8
W
Weight ...........................................................10-6
Z
Zero font with slash .......................................3-30
Index