Filter
Top Products
xi
●●
Components and functions
.5
x
15F . TR REAR 1
F. TR
R. TR
MAN
CSF
: Front Tractor
: Rear Tractor
: Manual
: Cut Sheet Feeder
REAR
TOP
FRNT
: Rear
: Top
: Front
1inch=25.4mm
Paper In
Paper Out
15: 15 inches 12: 12 inches 10: 10 inches 5: 5 inches
Paper Width (Fanfold Paper)
2
16.5
A3
A4
A5
Page Length (Fanfold Paper)
Paper Size (Cut Sheet Paper)
: 2 inches
: 16.5 inches
: A3
: A4
: A5
LT
HLT
LG
EX
GLT
GLG
LD
F4
PC
C6
C10
MN
DL
C5
: LETTER
: HALF LETTER
: LEGAL
: EXECUTIVE
: GOVERNMENT LETTER
:
GOVERNMENT LEGAL
: LEDGER
: F4 SIZE
: POST CARD
: COMMERCIAL-6
: COMMERCIAL-10
: MONARCH
: DL Envelope
: C5 Envelope
Feeds the perforation of fanfold paper to the paper
cutter poistion. (For fanfold paper only)
(ALT + TEAR OFF keys)
Press these keys for two seconds or more. Release
the keys when "INITIAL" is displayed on the LCD.
The printer will be reset.
Changes the paper path display. To select the
displayed paper path, press the ENTER key.
(ALT + PAPER PATH keys)
When paper is loaded, the current printing position is
considered as the TOF position.
Loads paper or feed back paper to the parking
position when fanfold paper is used. Loads or
and ejects paper when cut sheet paper is uesd.
(ALT + EJECT/LOAD keys)
Changes the printing quality display. To select
the displayed mode, press the ENTER key.
Enters the SETUP MODE.
Quits the SETUP MODE or EXTENDED
SETUP MODE.
(ALT + SETUP keys)
Enters the EXTENDED SETUP MODE.
Selects an item displayed in the SETUP MODE,
the EXTENDED SETUP MODE, setting the
paper path, setting the paper form or setting the
printing quality.
1
2
3
4
5
6
10
11
12
13
14
15
16
17
7
9
8
When pressing the corresponding key while you
press the ALT key, one of the following
functions is executed.
Changes the printing enable (online) state and
printing disable (offline) state.
Changes the paper form display. To select the
displayed paper form, press the ENTER key.
Feeds one page.
Feeds one line in the forward direction at a pitch
of 1/6 inch.
(ALT + LINE FEED keys)
Feeds one line in the forward direction at a pitch
of 1/360 inch.
(Micro line feed)
Feeds one line in the reverse direction at a pitch
of 1/6 inch.
(ALT + REVERSE LF keys)
Feeds one line in the reverse direction at a pitch
of 1/360 inch.
(Micro reverse line feed)
18
State display LCD
Keys on the panel
LINE FEED
REVERSE LF
SET UP
EJECT/LOAD
PAPER PATH
TEAR OFF
MICRO LF
MICRO RLF
EXTENDED SETUP
QUALITY
TOF SET
RESET
1
Orientation (Cut Sheet Paper)
p: Portrait l: Landscape
Page
Length
Control panel explanation 2