Filter
Top Products
5-9
— 5. Bar code and enlarged character function —
●
The HRI is adjusted to the center of the bar code symbol
width and printed at 10 cpi unless EAN or UPC guard bar
expansion is executed. If EAN or UPC guard bar
expansion is executed, an HRI is printed at the equal space
between the center guard bar and the left or right guard
bar.
If the HRI width is greater than the bar code symbol width,
the HRI printing pitch is reduced to print the HRI in the
same width as the bar code symbol width.
●
The HRI is printed below a bar code symbol, the vertical
printing position is lower than the printing start position
by (bar code height - 1/6”). If it is printed above the bar
code symbol, the vertical printing position is higher than
the printing start position by (1/6” - 24/180”).
●
When Code 11 is selected, small triangle (
▲▲
) and large
triangle (
▲▲
) are printed as the start and stop characters,
respectively. (This does not depend on the setting of the
check character.)
●
When Code 93 is selected, white squares (
■■
) are printed
as the start and stop characters, and a black square (
■
) is
printed as the control character. A printable character
expressed in combination with the control character is
printed as is. (For example, 61H is printed as ‘a’, not ‘
■
A’.)
●
When Code 128 is selected, black rhombuses (
◆
) are
printed instead of non-printable characters (00H to IFH
and 7FH).
H R I
●
Bar code function