Filter
Top Products
149Setup
Chapter 1 DVS-9000 Functions
Note that the setup data in RAM can also be saved to the control panel hard disk
or memory card.
Panel Setup
In panel setup, you carry out settings particular to the control panel.
You can make the following settings.
For details of the operations, see “Setup Relating to Operations From the
Control Panel” in Chapter 16 (Volume 2).
Panel settings (Config)
• M/E Assign: Set the logical configuration of the M/E and P/P banks.
• M/E Operation: For each of the M/E and P/P banks, make operations
possible, not possible, or disabled (Enable/Disable/Inhibit).
• DSK Fader Assign: Carry out fader function assignment and key delegation
for the key delegation buttons, in each of the maximum of four downstream
key control blocks.
• External Bus Link: Make link settings relating internal switcher buses to
routing switcher destinations.
• Key Trans Link: Select whether or not to link transitions between keyers,
and if so which keyer to link to. You can set the links between keyers for each
M/E bank separately.
• Reference Module: When a trackball module and a joystick module are both
connected as device control blocks, select which is used as the reference.
• 10 Key Region Assign: Assign any regions to the region selection buttons
in the numeric keypad control block.
• Program Button: Make settings for using the buttons in a standard type
transition control block for controlling a VTR.
Cross-point button settings (Xpt Assign)
• Multi Xpt Assign: For each operating bank or bus, assign a main table and
“sub” tables 1 to 4.
• Xpt Assign: Carry out main table settings.
– Assign video/key sources for button numbers 1 to 128.
– Set source names of up to 16 characters.
– Set the LCD color for source name display.
– For each cross-point table, specify whether the rightmost cross-point
button in each row is used as a shift button, and the operation mode when
it is used as a shift button.
• Sub Table Assign: For sub tables 1 to 4, set rearrangements of the button
layout set in the main table. Also set the shift button mode.