Filter
Top Products
Chapter 2 Menus and Control Panel
176
Names and Functions of Parts of the Control Panel
to [KEY4]) corresponding to the key you
want to bring to the front.
i KF (keyframe) button
When the VTR operation mode is enabled
in setup, pressing this button cues the tape
automatically to the start point.
The following controls are used as the
independent key transition control block.
j Key delegation buttons
These buttons delegate this independent
key transition control block to a desired
keyer. Press one of the [KEY1] to [KEY4]
buttons ([DSK1] to [DSK4] in the PGM/
PST bank), turning it on.
You can press more than one button to
select two or more keyers.
k Independent key transition type
selection buttons
Press one of the following buttons, turning
it on, to select the independent key
transition type.
MIX: Faded in or out.
WIPE: Inserted or deleted with a wipe.
DME (DME wipe): Inserted or deleted
with a DME wipe.
l Independent key transition
execution section
KEY1 ON to KEY4 ON (DSK1 ON to
DSK4 ON in the PGM/PST bank)
buttons: Press the corresponding one
of these buttons to cut key 1 to key 4 in
or out instantaneously. When the key
corresponding to the button appears in
the final program output, the button
lights red, and otherwise lights amber.
AUTO TRANS (transition) buttons:
These correspond to keys 1 to 4 from
left to right; press one to carry out an
auto transition. The transition rate for
an independent key transition can be
set in the numeric keypad control
block, in the Flexi Pad control block, or
in a menu.
m Key source name display/key
snapshot buttons
These display the source name selected on
the corresponding keyer. In key snapshot
mode, press these buttons, corresponding to
registers 1 to 4 for the selected keyer, to
save or recall a key snapshot.
n Key snapshot setting buttons
K-SS (key snapshot): This enables key
snapshot mode.
K-SS STORE (key snapshot store): To
save a key snapshot, hold down this
button, and press the key source name
display/key snapshot button
corresponding to the register you want
to save.
K-MOD ENBL (key modifier enable): To
recall key adjustment values and key
modifier settings when recalling a key
snapshot, press this button, turning it
on.
K-TR ENBL (key transition enable): To
recall independent key transition
settings when recalling a key snapshot,
press this button, turning it on.