Filter
Top Products
337Basic Procedure for DME Wipe Settings
Chapter 6 DME Wipes
Setting the DME wipe pattern size (Size)
Use the following procedure.
1
In the M/E-1>DME Wipe menu, select HF5 ‘Modify.’
The Modify menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
3
Press [Size], turning it on.
4
Set the following parameters.
a) The current effect size of the DME wipe pattern is taken as 100.00%.
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
Adjusting the DME wipe pattern cropping
Use the following procedure.
1
In the M/E-1>DME Wipe menu, select HF5 ‘Modify.’
The Modify menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
Knob Parameter Adjustment Setting values
1 Size Set size of effect
0.00 to 200.00
a)