Filter
Top Products
Chapter 5 Wipes
312
Basic Procedure for Wipe Settings
• When soft edge is selected
• When soft border is selected
4
When you selected border or soft border, select the edge fill signal in the
<Edge Fill> group.
Utility 2 Bus: signal selected on the utility 2 bus
Matte: signal from the dedicated color matte generator
5
Depending on the operation in step 4, carry out the following operation.
When ‘Utility 2 Bus’ is selected: Hold down the [UTIL] button in the
cross-point control block, and select the signal on the background B
bus.
While the [UTIL] button is held down, the background B bus changes
to the utility 2 bus.
Note
To enable the [UTIL] button, its operation mode must be set to [Hold]
beforehand. (See “Operation Settings (Operation Menu)” in Chapter
16 (Volume 2).)
When ‘Matte’ is selected: In the same Edge/Direction menu, press [Matte
Adjust] to display the Matte Adjust menu, then adjust the single-color
or two-color combination color matte. Select whether to use a single-
color matte or a two-color combination in the <Edge Matte> group.
Flat Color: Adjust color 1 with the following parameters.
When you select Mix Color for a two-color combination, see the next
paragraph.
Knob Parameter Adjustment Setting values
1 Soft Edge softness 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Width Border width 0.00 to 100.00
2 Inner Soft Border inner softness 0.00 to 100.00
3 Outer Soft Border outer softness 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00