Filter
Top Products
Chapter 1 DVS-9000 Functions
154
Setup
• Xpt Hold mode: Set the operation mode for the cross-point hold button
provided on the key bus for each of the M/E and P/P banks.
• Pattern Limit Transition: Set the operation mode when the pattern limit is
released for each of the M/E and P/P banks.
• Wipe Edge Default: Adjust the wipe edge softness for each of the M/E and
P/P banks.
• FM Auto Store: Switch on or off the function to automatically attach a name
and save in frame memory.
Link settings (Link)
• Internal Bus Link: Make a setting of the bus link function that links
together two buses internal to the switcher.
• GPI Link: Make settings for linking any cross-point buttons or [CUT] and
[AUTO TRANS] buttons in the cross-point control block and GPI output
ports.
External device connections (Device Interface)
• Remote Assign: Set the use of the four 9-pin ports.
• GPI Input: Set the GPI input ports and trigger polarities, and make the
action settings.
• GPI Output: Set the GPI output ports and trigger polarities, and make the
action settings.
• Aux Control: Set whether operations on the Aux buses from the four 9-pin
ports are inhibited.
DME Setup
In DME setup, carry out settings particular to the DME processor.
You can make the following settings.
Input signal settings (Input)
• Initial Crop: Make the initial crop setting.
• Matte Illeg. Color Limit: Switch the illegal limiter for the signal generated
by the DME internal matte generator on or off.
Interface with external devices (Device Interface)
• Editor Protocol: Set the protocol to be used on the Editor port.
• Editor Port Setting: Make settings relating to the control of the four editor
ports installed in the DME.
• GPI Input: Set the GPI input ports and trigger polarities, and make the
action settings.