Filter
Top Products
247Transition Preview
Chapter 3 Transitions
Transition Preview
Carrying out a transition preview
To carry out a transition preview, use the following procedure.
For an overview of the transition preview, see page 44.
1
In the M/E or PGM/PST bank transition control block, press the [TRANS
PVW] button.
The [TRANS PVW] button lights green, and the switcher is now in the
transition preview mode. At this point, the preview output is the same as
the program output before the [TRANS PVW] button was pressed.
2
Operate the fader lever, or press the [AUTO TRANS] button or [CUT]
button.
On the preview monitor, you can check the effect of the transition.
To terminate a transition preview
There are three modes for a transition preview. To terminate a transition
preview, carry out the operation which depends on the mode, and press the
[TRANS PVW] button, turning it off.
Lock: Toggling the [TRANS PVW] button on and off switches between the
transition preview mode and the normal mode.
Hold: The preview mode obtains only while the [TRANS PVW] button is held
down.
One Time: Each time a transition ends, it reverts to the normal mode.
For details of the mode setting, see “Operation Settings (Operation Menu)”
and “Settings Relating to Video Switching (Transition Menu)” in Chapter 16
(Volume 2).
Notes
• During a transition, whether executed with the [AUTO TRANS] button or
the fader lever, it is not possible to press the [TRANS PVW] button.
• In bus fixed mode (see page 43), transition previews are not available.
• When using the simple-type transition control block (see page 255),
transition previews are not available.