Filter
Top Products
183Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
Device Control Block (Trackball)
The device control block is used for three-
dimensional transform operations using a
DME, for wipe pattern position setting, and
for VTR operation.
a Region selection buttons
The operation mode allocated to the device
control block depends on the selection state
of the region selection buttons.
When the [M/E 1], [M/E 2], [M/E 3], and
[P/P] buttons are selected: This
enables the wipe pattern position
setting (positioner) operation mode in
the device control block. You can
select multiple buttons simultaneously.
When the [USER] button is selected: This
enables pattern position setting used
for color backgrounds.
When the [DME 1] to [DME 4] buttons
are selected: This enables the three-
dimensional transform operation mode
in the device control block.
Press a button, turning it on, to select a
DME channel. You can select multiple
buttons simultaneously.
The number of valid buttons depends
on the number of DME processor
channels installed.
When the [DEV] button is selected: This
enables the VTR operation mode in the
device control block. In this state, the
[M/E 1] to [M/E 3] buttons, P/P button
and DME1 to DME8 buttons function
as the device 1 to device 12 allocation
buttons as follows.
M/E1 (DEV1): device 1
M/E2 (DEV2): device 2
DEVUSER
M/E1
DME1
DME5
MENU
SHIFT
M/E2
DME2
DME6
ASP
PERS
SUB
LOC
SIZE
FMR1
AXIS
LOC
MAIN
LOCAL
K1
CB1
GLB
K2
CB2
CLR
WORK
BUFR
M/E3
DME3
DME7
SRC
K3
FM1
TRGT
K4
FM2
LOC
XYZ
FMR2
X
P/P
DME4
DME8
ROT
POS
Y
Z CTR
RUN
CTRL
1 Region selection buttons
3 Trackball
4 Z-ring
2 Operating buttons
5 MENU button