Filter
Top Products
Chapter 5 Wipes
306
Basic Procedure for Wipe Settings
• When a random wipe is selected (pattern number 273)
• When a diamond dust wipe is selected (pattern number 274)
Note
When Flash Rate is set to 0.00, you cannot change the pattern. In this state,
adjusting H Size or V Size has no effect on the pattern.
For details of a pattern mix, see the next section.
For details of applying pattern modifiers, see “Setting Wipe Modifiers”
(page 309).
Selecting a wipe pattern in the Flexi Pad control block
To select a pattern with a standard type Flexi Pad control block, use the
following procedure. (It is not possible to select a wipe pattern with a simple
type Flexi Pad control block.)
1
In the M/E-1 Flexi Pad control block, press the [WIPE] button.
This switches the Flexi Pad control block to wipe snapshot mode.
Knob Parameter Adjustment Setting values
1 H Size Tile width 0.00 to 100.00
2 V Size Tile height 0.00 to 100.00
3 Volatility Rate of tile generation 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 H Size Particle width 0.00 to 100.00
2 V Size Particle height 0.00 to 100.00
3 Flash Rate Rate of generation of particles 0.00 to 100.00