Filter
Top Products
293Key Setting Operations With the Key Control Block
Chapter 4 Keys
Setting the outline parameters
When the [OUTLINE] button is lit green, the parameter settings depend on the
key type and whether the separate edge function is active. To activate the
separate edge function, press [Separate Edge], setting it on, in the Edge menu
for the key.
• Separate edge off
a) In the “4H mode” and when [Fine Key] (page 276) is on, the setting value range is 0 to 4.
b) When a wipe pattern key or key wipe pattern key is selected as the key type
• Separate edge on
The outline width settings can be made independently for left, right, top, and
bottom sides. The separate edge function is only available when luminance
key, linear key, or chroma key is selected as the key type.
a) In the “4H mode” and when [Fine Key] (page 276) is on, the setting value range is 0 to 4.
When [Outline] is selected with separate edge on, the [MORE] button lights
amber. Pressing the [MORE] button to turn it green then allows you to adjust
the key fill density parameter with a knob.
Setting the embossing parameters
When the [EMBOS] button is lit green, adjust the following parameters.
4 Density Density 0 to 100
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 Width Outline width
0 to 8
a)
(0 to 100)
b)
4 Density Outline density 0 to 100
Knob Parameter Adjustment Setting values
1 Top Top edge width
0 to 8
a)
2 Left Left edge width
0 to 8
a)
3 Right Right edge width
0 to 8
a)
4 Bottom Bottom edge width
0 to 8
a)
Knob Parameter Adjustment Setting values
4 Density Outline density 0 to 100
Knob Parameter Setting values
1 Width 0 to 4