Filter
Top Products
Chapter 3 Transitions
260
Simple Transition
If, in the Setup menus, you set insertion and deletion as independent
modes, make the settings for the next transition in the independent key
transition control block.
Separate settings are required both when inserting a key and when deleting
it. For example, with the key not inserted, if you select the transition type
and carry out a transition, this will be the setting when inserting a key.
2
Carry out the transition in the independent key transition execution
section.
To insert or delete the key gradually with a mix or wipe transition:
Press the [TAKE] button.
To set the independent key transition rate using a simple-type transition
control block, use the key 3 and key 4 Transition menus. For details, see
“Setting the Independent Key Transition Rate” (page 250).
To cut the key in or out instantaneously: Press the [KEY 3 ON] button
or [KEY 4 ON] button.
Note
In an independent key transition, the pattern limit function is not available.