Filter
Top Products
147
INSTALLING THE
PRINTER DRIVER
for Macintosh
The Print screen is shown when [Print] is selected from the [File] menu.
Customizing the settings in the Print screen allows enlarged/reduced printing, layout printing,
and so on. This section describes “Printer Specific Options”, specific to the e-STUDIO16/20/25.
SUPPLEMENT:
The other settings of the driver should be performed in the LaserWriter setup. For further
information on settings, please see the Macintosh manual or Help.
Printer Specific Options 1
➀ Offset Stack
Select On or Off to use the Offset Stack function for printing.
➁ Toner Saving
Select On or Off to use the Toner Saving function for printing.
➂ Paper Destination
Select the destination of the output.
● Standard Output Tray
As a default setting, this is selected. The printed paper is ejected into the general output tray.
● Job Separator Upper Tray
The printed paper is ejected on to the Upper Tray of the Job Separator. This is available only when the Job
Separator is installed.
● Job Separator Lower Tray
The printed paper is ejected on to the Lower Tray of the Job Separator. This is available only when the Job
Separator is installed.
● Finisher Tray1
The printed paper is ejected on to the Upper Tray of the Finisher. This is available only when the Finisher is installed.
● Finisher Tray2
The printed paper is ejected on to the Lower Tray of the Finisher. This is available only when the Finisher is installed.
Printer Specific Options