Filter
Top Products
66
SETUP IN BINDERY MODE
Confirmation before setting up
Confirm Bindery Context
The print server is set up in the bindery mode of NetWare 4.x. It is set in the bindery mode when
you want to preserve the environment of the existing NetWare 3.x or to allow clients of NetWare
3.x to use the print server.
Before using the print server in the bindery mode, bindery context must be stored in the
NetWare 4.x server. Check if bindery context exists there. For the bindery mode, refer to the
Operator’s Manual for NetWare.
To confirm that the server has a Bindery Context, perform the following steps by through the
console prompt at the NetWare server.
Type load install and press Enter key.
Select NCF Files Options from the menu.
Select Edit AUTOEXEC.NCF from the menu.
View the screen to Edit AUTOEXEC.NCF file.
Search the file to see if you have a statement similar to the following included:
SET BINDERY CONTEXT=0U=ENG
● If the Bindery Context is “SET BINDERY CONTEXT=0U=ENG,” that means the server has a Bindery.
● When you do not have such a statement, add the statement and save it by pressing F10.
Press Alt+F10 to complete the confirmation.
● If the new statement is added, the definition in the file takes effect when the server is shut down and then
restarted. If you want the Bindery Context applied frequently, type the new statement by the console
prompt and press Enter.
1
2
3
4
5
6