Configuring IPX for Remote Sites Connection
9-3
Modifying or
Deleting an IPX
Network
To modify information pertaining to an existing IPX network or to delete
that information from your configuration, follow these steps:
1 Proceed to the IPX screen, following steps from the previous section.
2 Select an IPX network you wish to modify or delete.
3 Click Modify/Delete.This brings up the IP Modify/Delete screen
containing the following fields:
4 You may enable or disable the selected IPX network by clicking Modify
or Delete.
5 Click Modify after you have entered your fields.
If you need to return to the original parameters for this screen, click the
Reset button before you click Modify.
Configuring IPX for
Remote Sites
Connection
To set up a protocol over the WAN, a remote site profile must be created
and edited for each remote location you want to connect to. With this
profile, you specify virtual circuit (VPI, VCI) information, protocols, and
addresses that determine the method of connection and communication
to that remote site.
The steps you take to assign a network over the WAN are quite different
from those to assign a network over the LAN. First you add a remote site
profile, then you modify the profile to include the WAN network
information, such as IPX addresses and IPX routing.
840ug.book Page 3 Friday, July 7, 2000 2:23 PM