3Com 3C840 Network Router User Manual


 
10
U
PGRADING
O
PERATIONAL
S
OFTWARE
FOR
THE
O
FFICE
C
ONNECT
R
EMOTE
840
Introduction
This chapter details the updating of the OfficeConnect Remote 840
software. It is divided into the following sections:
“Obtaining Updated OfficeConnect Remote 840 Software”
“Installing Operational Software to the OfficeConnect Remote 840
Unit”
Obtaining Updated
OfficeConnect
Remote 840
Software
The OfficeConnect Remote 840 operational software is stored in the
unit's FLASH memory. In order to update the operational software, you
must first obtain and copy it to your PC's hard drive. You can then install
it into FLASH memory on the OfficeConnect Remote 840.
The method of obtaining the latest versions of the OfficeConnect Remote
840 Operational Software is either via the 3Com website,
www.3com.com/ocr840 or via the CD. Install the latest version
software from the website or the OfficeConnect Remote 840 CD. Type
show system, using the CLI interface, to verify the version software
installed on your OfficeConnect Remote 840.
If you have erased the operational software from your OfficeConnect
Remote 840, you will need to reinstall the software using a utility on your
CD. Follow the procedure described in “Installing Software via DOS”
.
Once you obtain the OfficeConnect Remote 840 operational software,
there are two methods of installing the software into the FLASH memory.
OfficeConnect Remote 840 Manager Software Update (preferred
method).
DOS Update.
840ug.book Page 1 Friday, July 7, 2000 2:23 PM