3Com 3C840 Network Router User Manual


 
Configuring Network Service Information (PPP / RFC 1483 / RFC 1490)
3-5
4 Select the network service to be either RFC 1483, or PPP.
If PPP, enter the Authentication Name and Authentication Password
provided to you. You can change the header compression from the
default of none to TCP/IP if you wish.
5 Click Next to proceed to the ATM Configuration screen.
Frame Relay
1 If your unit is using Frame Relay, the Remote Sites General Modify
screen will contain the following fields:
2 Enter a name to identify the remote site.
3 Select Network Service to either PPP over Frame Relay or RFC 1490.
If you select PPP over Frame Relay, enter the Authentication Name and
Authentication Password provided to you. You can change the header
compression from the default of None to TCP/IP if you wish.
4 Enter the DLCI.
5 Check the Enable Bridging and Enable MAC Encapsulated Routing
boxes according to your service provider’s directions.
840ug.book Page 5 Friday, July 7, 2000 2:23 PM