Filter
Top Products
1-6
C
HAPTER
1: O
VERVIEW
within the same subnet. When the local side of the WAN interface has an
assigned address, it is referred to as being "numbered." Otherwise, it is
referred to as "unnumbered."
For a more in-depth description of “numbered” versus “unnumbered”
interfaces, see Appendix B, “IP Addressing”
.
When PPP is used, both the local and remote WAN addresses can by
dynamically learned. Otherwise, they must be specified. The diagram
below shows a OfficeConnect Remote 840 with 3 VCs and the
corresponding IP addresses.
When PPP is used, both the local and remote WAN addresses can by
dynamically learned. Otherwise, they must be specified. The diagram
below shows an OfficeConnect Remote 840 with 3 VCs and the
corresponding IP addresses.
Figure 1–3 Connection with Three Virtual Circuits (VCs)
What is RFC 1483
RFC 1483 is a protocol standard that describes two encapsulations
methods for carrying network interconnect (Bridging and Routing) traffic
over ATM AAL5.
RFC 1483 is a single-link interface between two packet-switching devices,
such as a bridge or router. An RFC 1483 link may be created between the
OfficeConnect Remote 840 and a remote router after they establish a
840ug.book Page 6 Friday, July 7, 2000 2:23 PM