Filter
Top Products
E-4
A
PPENDIX
E: C
ONFIGURATION
(N
ON
-S
ETUP
W
IZARD
)
OF
THE
O
FFICE
C
ONNECT
R
EMOTE
840
Step 2: Configuring
the Remote Site ATM
Parameters (ATM
Only)
The ATM Modify screen is to be filled in with information from the
Configuration Planning Forms in Chapter 1 of the Installation Guide.
The screen contains the following fields:
1 Enter the information in these fields as contained in the Configuration
Planning Forms.
■
Enter the Virtual Path Identifier (VPI) and the Virtual Channel Identifier
(VCI) for the virtual channel you are configuring.
■
If necessary, enter any upstream Category of Service parameters
that may have been provided to you.
■
The default value of UBR with a Peak Cell Rate (PCR) of 0 will attempt
to use all available bandwidth when transmitting.
2 Press Next to continue on to the IP Modify Screen.
Step 3: Configuring
the Remote Site IP
Network Information
The IP Modify screen contains the following fields.
840ug.book Page 4 Friday, July 7, 2000 2:23 PM