Filter
Top Products
Configuration Overview
1-13
Configuration
Overview
The OfficeConnect Remote 840 configuration is divided into three areas:
Local Site (LAN), Remote Site (WAN), and Global configuration. The
following shows the areas of configuration for each.
To successfully configure the OfficeConnect Remote 840 to route or
bridge a network, you should perform the following steps.
General
Configuration Steps
The following steps provide an outline to follow when configuring the
OfficeConnect Remote 840 to route or bridge. For detailed instructions
on first time installation and basic configuration, see the OfficeConnect
Remote 840 SDSL Router Install Guide.
Perform the following steps to configure the OfficeConnect Remote 840
to route or bridge a network:
1 Complete the appropriate Configuration Planning Form. A form is
provided in the box when you purchase your OfficeConnect Remote 840.
Copies of the forms are provided in the OfficeConnect Remote 840 SDSL
Router Install Guide for your convenience.
2 Install the OfficeConnect Remote 840 utilities from your OfficeConnect
Remote 840 CD. If necessary, install a web browser on your workstation
(Microsoft Internet Explorer 4 is included on the CD).
3 Connect to the OfficeConnect Remote 840 through either the web
browser or the CLI.
4 Configure the OfficeConnect Remote 840.
■
Ethernet Interface Protocols
■
IP, IPX, Bridging
■
Remote Sites
■
Global Parameters
■
Run the configuration audit.
■
Save the configuration.
Local Site Remote Site Global
IP
IPX
Bridging
Network Service
ATM
IP
IPX
Static WAN Routes
Bridging
DHCP
DNS
Administrative
840ug.book Page 13 Friday, July 7, 2000 2:23 PM