Managing a Remote Site Profile
3-3
4 Click Add. Then click Save Configuration on the sidebar to
permanently save the changes.
The Network Service (PPP and RFC 1483/ RFC 1490), ATM, and network
protocol (Bridging, IP, and IPX) information has not been configured yet.
To make a connection with the remote site you must configure the
Network Service, ATM, and at least one network protocol. (See
“Configuring Network Service Information (PPP / RFC 1483 / RFC 1490)”
,
“Configuring ATM Information”
, and “Configuring Protocol Parameters”
for details.)
Modifying a Remote
Site Profile
1 From the OfficeConnect Remote 840 home page, select Configuration
> Remote Site (WAN).
2 Select the name of a remote site profile and click Modify. This brings up
the Remote Site General Modify screen.
3 Change configuration parameters as needed and use the Next button to
continue to the ATM, IP, IP Advanced, and IPX configuration screens.
For quick help on specific parameters, click the Help button located at
the bottom of each screen.
For more detailed help, go to the appropriate place in this guide (see
“Configuring ATM Information”
and Configuring Other WAN
Parameters).
■
Click Modify on any screen to set all the Remote Site parameters.
■
Click Save Configuration on the sidebar to permanently save the
changes.
Deleting a Remote
Site Profile
1 From the OfficeConnect Remote 840 home page, select Configuration
> Remote Site (WAN).
2 Select the name of a remote site profile and click Delete. This brings up
the Remote Site General Delete screen.
3 To delete the profile, click Delete. To return to the remote site profile
selection list, click Prev.
840ug.book Page 3 Friday, July 7, 2000 2:23 PM