Filter
Top Products
Remarks:
When SRQ0 is issued, the SRQ will no long turn off and on with each
reading. The SRQ is set back on by the SRQ1 command or by requesting
data.
STA Restart averaging reading.
WAT Sets the display channel units to Watts.
Remarks:
Turns off relative mode. Relative is not available in this mode.
ZAJ Zero the sensor.
Remarks:
During the zero operation, the zero bit in the status byte is set. When the
zero operation is completed, the zero bit in the status byte is cleared.
When emulating the ML4803, the ML2430 may take longer to zero a sen-
sor than the ML4803 itself. When performing a zero, the status byte should
be used to identify when zeroing is complete.
6-94 ML2430A OM
ML4803A EMULATION COMMANDS GPIB OPERATION