Filter
Top Products
A-3
SYSTEM DEFAULTS
The following default parameters are loaded whenever preset is selected
from the front panel or through GPIB.
A-6 ML2430A OM
SYSTEM DEFAULTS APPENDIX A
SENSOR - setup
settle % per reading 0.10%
measurement mode default
range hold auto
SENSOR - cal factor
Source Frequency
source ( HP 437B & HP 438A ) manual
source = frequency
input signal frequency 50 MHz
source = manual
cal factor 100%
cal adjust 100%
input signal frequency 50 MHz
source = volts/GHz
start freq 10 MHz
stop freq 20 GHz
start voltage 0 volts
stop voltage 10 volts
units percent
SENSOR - averaging
SYSTEM - setup = readout or power vs. time
mode auto
mode ( HP 437B & HP 438A ) auto
mode = moving
mode = repeat
averaging number 64
auto low level averaging low
SYSTEM - setup = profile
graph averaging state off
between cursor average on
SENSOR - offset
offset type off
offset type ( HP 437B ) off
offset type ( HP 438A ) fixed
offset type = fixed
offset value 0 dB
offset type = table
table number 1