Filter
Top Products
If any error, other than a DSP error, is encountered, the text:
“Press ANY key to continue”
will be displayed at the bottom of the screen. If only warnings are
encountered, nothing will be displayed at the bottom of the screen, and
the unit will continue to initialize.
If a DSP error occurs, the text:
"Restart unit. If error persists, con
-
tact Service Center."
is displayed and the unit will halt the self test. Make note of the hexadeci
-
mal error code displayed and contact your nearest Anritsu Service Center
(see Chapter 2, Table 2-1).
Self test error messages are also available over the GPIB, as a self test
status string (see STERR command, page 6-74).
4-4 ML2430A OM
POWER-ON PROCEDURE OPERATION