Anritsu ML2430A Power Supply User Manual


 
SAFETY-2 ML2430A OM
When supplying AC power to this equipment, connect the accessory 3-pin
power cord to a 3-pin grounded power outlet. If a grounded 3-pin outlet is
not available, use a conversion adapter and ground the green wire, or con-
nect the frame ground on the rear panel of the equipment to ground. If
power is supplied without grounding the equipment, there is a risk of re-
ceiving a severe or fatal electric shock.
WARNING
This equipment cannot be repaired by the operator. DO NOT attempt to re
-
move the equipment covers or to disassemble internal components. Only
qualified service technicians with a knowledge of electrical fire and shock
hazards should service this equipment. There are high-voltage parts in this
equipment presenting a risk of severe injury or fatal electric shock to un
-
trained personnel. In addition, there is a risk of damage to precision com
-
ponents.
WARNING
WARNING
Repair
For Safety
WARNING
Always refer to the operation manual when working near locations at
which the alert mark, shown on the left, is attached. If the operation, etc.,
is performed without heeding the advice in the operation manual, there is
a risk of personal injury. In addition, the equipment performance may be
reduced.
Moreover, this alert mark is sometimes used with other marks and de
-
scriptions indicating other dangers.
If this equipment is used in a manner not specified by the manufacturer,
the protection provided by the equipment may be impaired.
WARNING