Filter
Top Products
Error Message Meaning
SENSOR A not fitted
READING SENSOR A data
Sensor A is required for the current
measurement, but is not fitted.
as per message
SENSOR B not fitted
READING SENSOR B data
Sensor B is required for the current
measurement, but is not fitted.
as per message
Printer buffer full
Printer - Check paper
Printer Error
Try selecting print, when current job finished.
Printer reporting “0ut of paper.”
Printer communication error.
Chan1-NOtrigger
Chan2-NOtrigger
Waiting for trigger on specified channel for
more than 6 seconds
Increase PERIOD to>6ms WARNING: In profile mode, when using
manual or continuous trigger, the data col
-
lection period must be>6ms.
Graph Display HELD warning message
Updating SENSOR data Programming SENSOR EEPROM
Graph Channel Off In any graph mode, the selected display
channel is off.
Ext Volts ZERO in progress as per message
Put sensor number limit Attempt to read/write sensor B setup on
ML2437A
Sensor A cal factor error Cal factor out of range - sensor A
Sensor B cal factor error Cal factor out of range - sensor B
PUT current mode limit Present configuration will not allow re
-
quested change.
Internal error (P6) Entered numeric value out of range
Internal error (P10) Requested action NOT allowed
Internal error (P20) Cal factor edit - duplicate frequency entered
Internal error (P21) Cannot delete last cal factor data pair in se
-
lected table, or cannot add cal factor data
pair in selected table
Internal error (P22) Cannot delete 50 MHz cal factor in selected
table
Internal error (P23) Non valid cal factor table
A-12 ML2430A OM
SYSTEM ERROR MESSAGES APPENDIX A