Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 116
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
6.2 System
System Information, System Name/Password, IP Address, ARP Table, Route Table,
Save Configuration, Firmware Upgrade, Alarm Setting, Reboot, Logout
System Name/Password
System Name:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage: Use the hostname command to set or change the network server name.
Use the no hostname command to disable this function.
3. Command Syntax: (no) hostname HOSTNAME
HOSTNAME specifies the network name of the system
4. Example: The following example sets the hostname to Hardened Ethernet
Extender Switch, and shows the change in the prompt:
switch_a(config)#hostname switch
switch(config)#
Password:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode)
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage: Use enable password command to modify or create a password to be
used when entering the Enable mode.
3. Command Syntax: enable password PASSWORD
PASSWORD specifies the new password of the system.
4. Example: The following example sets the new password my passwd to the
Hardened Ethernet Extender Switch:
switch_a(config)#enablepasword mypasswd