Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 191
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the GVRP applicant state to normal or active.
3. Command Syntax:
set gvrp applicant state active/normal IFNAME
active Active state
normal Normal state
IFNAME Name of the interface.
4. Example:
The following example sets GVRP applicant state to active on the interface fe1
(port 1):
switch_a(config)#set gvrp applicant state active fe1
switch_a(config)#
Per port setting:
GVRP registration:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set GVRP registration to normal, fixed, and forbidden
registration mode for a given port.
3. Command Syntax:
set gvrp registration normal IF_NAME
set gvrp registration fixed IF_NAME