Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 149
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
Use the no spanning-tree autoedge command to disable this feature.
3. Command Syntax:
(no) spanning-tree autoedge
4. Example:
The following example enables the spanning-tree autoedge of the interface fe1
(port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree autoedge
switch_a(config-if)#
Edgeport:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use spanning-tree edgeport command to set a port as an edge-port and to
enable rapid transitions.
Use the no spanning-tree edgeport command to set a port to its default state (not
an edge-port) and to disable rapid transitions.
3. Command Syntax:
(no) spanning-tree edgeport
4. Example:
The following example enables the spanning-tree edgeport of the interface fe1
(port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree edgeport