Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 144
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
GROUP <1-1> The ID of the bridge group for which the priority is set.
PRIORITY <0-61440> The bridge priority.
4. Example:
The following example sets the priority PRIORITY (4096) of bridge GROUP (1):
switch_a(config)#bridge 1 priority 4096
switch_a(config)#
Hello Time (sec) (1..9):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the hello-time, the time in seconds after which (if this
bridge is the root bridge) all the bridges in a bridged LAN exchange Bridge
Protocol Data Units (BPDUs).
3. Command Syntax:
bridge GROUP hello-time HELLOTIME
no bridge GROUP hello-time
GROUP <1-1> The ID of the bridge group to which this hello time is assigned.
HELLOTIME <1-9> The hello BPDU interval in seconds.
4. Example:
The following example sets the hello-time HELLOTIME (9) of bridge GROUP (1):
switch_a(config)#bridge 1 hello-time 9
switch_a(config)#
Max Age (sec) (6..28):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.