Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 141
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
3. Command Syntax:
bridge GROUP protocol PROTOCOL vlan-bridge
GROUP <1-1> Bridge group name used for bridging.
PROTOCOL
ieee IEEE 802.1Q spanning-tree protocol.
mstp IEEE 802.1s multiple spanning-tree protocol.
rstp IEEE 802.1w rapid spanning-tree protocol.
4. Example:
The following example chooses the PROTOCOL (rstp) on bridge GROUP (1):
switch_a(config)#bridge 1 protocol rstp vlan-bridge
switch_a(config)#
Multiple Spanning Tree Protocol:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable the Multiple Spanning Tree protocol on a bridge.
Use the no form of the command to disable the Multiple Spanning Tree protocol
on a bridge.
3. Command Syntax:
bridge GROUP multiple-spanning-tree enable
no bridge GROUP multiple-spanning-tree enable BRIDGE-FORWARD
GROUP <1-1> Bridge group name used for bridging.
BRIDGE-FORWARD Puts all ports of the specified bridge into the forwarding state.