Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 168
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use mls qos map dscp-queue command to map the DSCP values to a queue.
3. Command Syntax:
mls qos map dscp-queue DSCP_VALUE to QUEUE_ID
DSCP_VALUE DSCP values. Up to 8 values (separated by spaces). Range is 0-63.
QUEUE_ID Queue ID. Range is 0-3.
4. Example:
The following example shows mapping DSCP values 0 to 3 to queue 1 on the
Hardened Ethernet Extender Switch:
switch_a(config)#mls qos map dscp-queue 0 1 2 3 to 1
switch_a(config)#
6.9 SNMP
SNMP General Setting, SNMP v1/v2c, SNMP v3
SNMP General Setting
SNMP Status:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use snmp-server enable command to enable and no snmp-server enable com-
mand to disable SNMP to the Hardened Ethernet Extender Switch.
3. Command Syntax:
(no) snmp-server enable