Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 183
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
4. Example:
The following example specifies to upgrade VDSL speed for Ethernet Extender
port 1 (vdsl1):
switch_a(config)#interface vdsl1
switch_a(config-if)#vdsl retrain
switch_a(config-if)#
VDSL Settings:
Enable/Disable Asymmetric Mode:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vdsl1 means Ethernet Extender port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vdsl1
switch_a(config-if)#
2. Usage:
Use this command to enable the asymmetric mode for Ethernet Extender port.
Use the no parameter with this command to disable the asymmetric mode for
Ethernet Extender port.
3. Command Syntax:
(no) vdsl asymmetric-mode
4. Example:
The following example specifies to enable the asymmetric mode for Ethernet
Extender port 1 (vdsl1):
switch_a(config)#interface vdsl1
switch_a(config-if)#vdsl asymmetric-mode
switch_a(config-if)#