Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 136
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
2. Usage:
Use storm-control multicast enable command to enable multicast traffic.
Use no storm-control multicast command to disable multicast traffic.
3. Command Syntax:
storm-control multicast enable
no storm-control multicast
4. Example:
The following example shows setting storm-control multicast enable to the
interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control multicast enable
switch_a(config-if)#
DLF:
1. Command Mode: Interface mode
Log on to Configure Mode (Configure Terminal Mode). Then log on to Interface
mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use storm-control dlf enable command to enable destination lookup failure traffic.
Use no storm-control dlf command to disable destination lookup failure traffic.
3. Command Syntax:
storm-control dlf enable
no storm-control dlf
dlf destination lookup failure