Filter
Top Products
Page 198
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if)#
2. Usage:
Use ip igmp snooping report-suppression command to enable report suppression
for IGMP versions 1 and 2.
Use the no ip igmp snooping report-suppression command to disable report
suppression.
3. Command Syntax:
(no) ip igmp snooping report-suppression
4. Example:
The following example enables report suppression for IGMPv2 reports on vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip igmp version 2
switch_a(config-if)#ip igmp snooping report-suppression
switch_a(config-if)#
NTP
NTP Status:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use ntp enable command to enable NTP for the Hardened Ethernet Extender
Switch.
Use no ntp enable command to disable NTP for the Hardened Ethernet Extender
Switch.
3. Command Syntax:
(no) ntp enable