Filter
Top Products
Page 176
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
2. Usage:
Add a user using snmp v3 with read-only or read-write access mode, MD5 or SHA
authentication, and privacy. Use the no form of the command to delete this user.
3. Command Syntax:
(no) snmp-server v3-user USERNAME (ro｜rw) priv auth (md5｜sha) AUTH_
PASSWORD des PRIV_PASS_PHRASE
USERNAME Specify a user name.
ro read-only access mode
rw read-write access mode
md5 authentication method
sha authentication method
AUTH_PASSWORD authentication password
PRIV_PASS_PHRASE encryption pass phrase
4. Example:
The following example adds a user (myuser) using snmp v3 with read-write access
mode, MD5 authentication (mypassword), and encryption pass phrase (mypass-
phrase):
switch_a(config)#snmp-server v3-user myuser rw priv md5 mypassword des
mypassphrase
switch_a(config)#
6.10 802.1x
Radius Configuration, Port Authentication
Radius Configuration
Radius Status:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use dot1x system-auth-ctrl command to globally enable authentication.