Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 154
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface
mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to assign a Multiple Spanning Tree instance to a port. Use the
no parameter with this command to remove the instance.
3. Command Syntax:
bridge GROUP instance INSTANCE_ID
no bridge GROUP instance INSTANCE_ID
GROUP <1-1> Specify the bridge-group ID.
INSTANCE_ID Specify the instance ID.
4. Example:
The following example assigns a Multiple Spanning Tree instance (3) to a port (fe1)
in bridge GROUP (1):
switch_a(config)#interface fe1
switch_a(config-if)#bridge-group 1 instance 3
switch_a(config-if)#
Bridge-Group Instance Priority:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#