Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 132
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
Port Security
Mode:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface
mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to enable port security for port.
Use the no parameter with this command to disable port security for port.
3. Command Syntax:
port-security enable
no port-security enable
4. Example:
The following example enables port security for interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#port-security enable
switch_a(config-if)#
Add/Delete MAC address:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface
mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#