Filter
Top Products
Page 122
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
4. Example:
The following example restores default setting of the Hardened Ethernet Extender
Switch:
switch_a#restore default
switch_a#
Auto Save:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable auto save configuration function. The configuration
will be automatically saved at every configured interval while this command is
enabled. Use the no form of this command to disable this feature.
3. Command Syntax:
service auto-config enable
no service auto-config enable
4. Example:
The following example enables or disables auto save configuration to Hardened
Ethernet Extender Switch:
switch_a(config)#service auto-config enable
switch_a(config)#no service auto-config enable
switch_a(config)#
Auto Save Interval (5–65536 sec):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#