Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 173
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
Use the no snmp-server trap-type enable linkUp command to disable link up trap
for SNMP.
3. Command Syntax:
(no) snmp-server trap-type enable linkUp
4. Example:
The following example enables link up trap for SNMP:
switch_a(config)#snmp-server trap-type enable linkUp
switch_a(config)#
SNMP v1/v2c
Get Community Name:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
Use snmp-server community get command to specify and no snmp-server
community get command to remove get community name for SNMP.
3. Command Syntax:
snmp-server community get NAME
no snmp-server community get
NAME The get community name for SNMP.
4. Example:
The following example specifies get community name (name) for SNMP:
switch_a(config)#snmp-server community get name
switch_a(config)#
Set Community Name:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#