Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 128
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
Duplex:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface
mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use duplex command to specify the duplex mode to be used for each interface.
Use the no duplex to disable this function.
3. Command Syntax:
(no) duplex MODE
MODE specifies the duplex mode: auto, full, half.
4. Example:
The following example shows the use of duplex MODE (full) to the interface fe1
(port 1):
switch_a(config)#interface fe1
switch_a(config-if)#duplex full
switch_a(config-if)#
Flow control:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface
mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#