Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 135
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface
mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use storm-control broadcast enable command to enable broadcast traffic.
Use no storm-control broadcast command to disable broadcast traffic.
3. Command Syntax:
storm-control broadcast enable
no storm-control broadcast
4. Example:
The following example shows setting storm-control broadcast enable to the
interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control broadcast enable
switch_a(config-if)#
Multicast:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface
mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#