Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 193
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
4. Example:
The following example enables IGMP snooping querier:
switch_a(config)# ip igmp snooping querier
switch_a(config)#
IGMP mode:
Passive:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use ip igmp snooping command to enable IGMP Snooping. This command is
given in the Global Config mode. IGMP Snooping is enabled at the Hardened
Ethernet Extender Switch level.
Use the no ip igmp snooping command to globally disable IGMP Snooping.
3. Command Syntax:
(no) ip igmp snooping enable
4. Example:
The following example enables IGMP snooping on the Hardened Ethernet
Extender Switch:
switch_a(config)# ip igmp snooping enable
switch_a(config)#
IGMP version:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The switch_a(config-if)# prompt will show on the screen.