Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 171
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify trap community name for SNMP.
Use the no parameter with this command to remove trap community name for
SNMP.
3. Command Syntax:
snmp-server trap-community <1-5> NAME
no snmp-server trap-community <1-5>
<1-5> The trap community 1-5.
NAME The trap community name for SNMP.
4. Example:
The following example specifies trap community name 1 (name) for SNMP:
switch_a(config)#snmp-server trap-community 1 name
switch_a(config)#
Trap Host IP Address:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify trap host IP address for SNMP.
Use the no parameter with this command to remove trap host IP address for
SNMP.
3. Command Syntax:
snmp-server trap-ipaddress <1-5> IP-ADDRESS
no snmp-server trap-ipaddress <1-5>
<1-5> The trap host IP address 1-5.