Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 174
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
2. Usage:
Use snmp-server community set command to specify and no snmp-server
community set command to remove set community name for SNMP.
3. Command Syntax:
snmp-server community set NAME
no snmp-server community set
NAME The set community name for SNMP.
4. Example:
The following example specifies set community name (name) for SNMP:
switch_a(config)#snmp-server community set name
switch_a(config)#
SNMP v3
SNMPv3 No-Auth:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Add a user using snmp v3 with read-only or read-write access mode and without
authentication. Use the no form of the command to delete this user.
3. Command Syntax:
(no) snmp-server v3-user USERNAME (ro | rw) noauth
USERNAME Specify a user name.
ro read-only access mode
rw read-write access mode
4. Example:
The following example adds a user (myuser) using snmp v3 with read-only access
mode and without authentication:
switch_a(config)#snmp-server v3-user myuser ro noauth