Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 117
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
switch_a(config)#
IP Address
IP Address/IP Subnet Mask:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if)#
2. Usage: Use the ip address command to remove the IP address from an
interface.
3. Command Syntax:
ip address IP-ADDRESS
no ip address IP-ADDRESS
no ip address
IP-ADDRESS A.B.C.D/M specifies the IP address and prefix length or an interface.
M specifies IP subnet mask, 8: 255.0.0.0, 16:255.255.0.0 24:255.25.255.0
4. Example: The following example sets the new IP address 192.168.1.10 and new
subnet mask 255.255.255.0 to Hardened Ethernet Extender Switch:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip addess 192.168.1.10/24
switch_a(config-if)#
Default Gateway:
1. Command Mode: Configure mode
Logon to ConfigureMode (Configure Terminal Mode)
The switch _a(config)# prompt will show on the screen.
switch_a(config)#