Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 143
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable the Spanning Tree protocol on a bridge.
Use the no form of the command to disable the Spanning Tree protocol on a
bridge.
3. Command Syntax:
bridge GROUP spanning-tree enable
no bridge GROUP spanning-tree enable BRIDGE-FORWARD
GROUP <1-1> Bridge group name used for bridging.
BRIDGE-FORWARD Puts all ports of the specified bridge into the forwarding state.
4. Example:
The following example enables or disables the spanning-tree on bridge GROUP
(1):
switch_a(config)#bridge 1 spanning-tree enable
switch_a(config)#no bridge 1 spanning-tree enable bridge-forward
switch_a(config)#
Bridge Priority (0..61440):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set bridge priority for the common instance. Using a lower
priority indicates a greater likelihood of the bridge becoming root.
3. Command Syntax:
bridge GROUP priority PRIORITY
no bridge GROUP priority